MACKIE ONYX 1640I - Manual (Page 37)

Owner's Manual 37
6. The Pod should drop down on to the chassis after a complete rotation. Give 'er a good wriggle if the screw
holes do not line up properly. Reattach the recently rotated Pod with the four screws removed in step 3.
Attach the rack ears to the mixer using the same silver fl athead screws removed from the side trim. The
rack ears are stamped with an 'R' or 'L' to denote which side of the mixer it goes on, based on house view.
Finally, attach the wire cover bracket with the screws that it arrived with.
NOTE: Be sure that the exposed cables are not pinched between the Pod and mixer body when seating
the rotated Pod.
Pod mounting screws
Pod mounting screws
wire cover bracket