Initio INI-9100UW User Manual
Page 34
3-7
in a similar fashion into the other SCSI device connectors as described
in the appropriate manufacturers instructions.
figure 3-4 Connecting the 50-pin internal flat ribbon cable
5. Drive activity LED
A drive activity LED is designed into the INI-9100U/9100UW host
adapter to indicate when a data transfer is being made. Connection to
the LED is optional and cabling is not included with this kit. The INI-
9100U/9100UW host adapter has a four pin connector located at J3
(refer to figure 3-1) to accommodate an LED cable.
6. Multiple Initiators
Under some circumstances multiple initiators can be used on a single
SCSI bus. The bus is configured to have more than one host adapter
inserted into at least two distinctly different computer systems sharing
peripheral devices. In theses circumstances, it is possible to have one
of the two computer systems turned off. Under theses conditions, the
INI-9100U/9100UW has a jumper JP1, that can be enabled (closed) to
set the active on-board termination on all the time, regardless of
whether power is applied or not. The host adapter is shipped without
the jumper installed and need not be changed in most cases.