Intel 410 - Manual (Page 58)

Getting Started – RAID Array 410 for Windows NT –Intel
B–2 EK–SMRAC-IG. C01
3. Set the communications parameters to:
• • 9600 baud
• • 8 bits
• • 1 stop bit
• • No parity
4. From your communication program, issue a connect command to establish a connection
with the controller, and then press the Enter key. You should see the CLI prompt, which
looks similar to
SWXRC>
From this prompt, you may issue your CLI commands. For further information regarding
CLI commands, reports, etc., refer to the SWXRC RAID Array Controller User’s Guide (EK-
SMCS1-UG).