InFocus LP 250 - Manual (Page 29)

29
Settings menu
Sources>Startup Source: this determines which source the projector
checks first for active signal during power-up.
Autosource : When this feature is On, the projector automatically finds the
active source, checking the Startup Source first. When this feature is Off, the
projector defaults to the source selected in Startup Source. To display
another source, you must manually select one by pressing the Computer or
Video
button on the remote or keypad.
System > Rear : reverses the image so you can project from behind a translu-
cent screen.
Ceiling : turns the image upside down for ceiling-mounted projection.
Display Messages : displays status messages (such as “Searching” or
“Mute”) in the lower-left corner of the screen.
Power Save : automatically turns the lamp off after no active sources are
detected for 5 minutes. The LED blinks green for one minute while the fans
continue to run to cool the lamp. If an active signal is received before the
projector powers down, the image will be displayed. You must press the
Power
button to display an image after 10 minutes have passed. This fea-
ture also makes the projector go into the startup state after it is powered on,
which allows you to turn ceiling mounted projectors on and off with a wall
power switch. When Power Save is enabled, Screen Save is disabled.
Screen Save : to preserve lamp life, the projector automatically blanks the
screen with a gray color after no signals are detected for 30 minutes. The
image returns when an active source is detected or a remote or keypad but-
ton is pressed. If you turn Screen Save on, the gray screen appears after 5
minutes.
Settings menu
Sources
Startup Source
System menu
p5p7 manual.fm Page 29 Thursday, January 9, 2003 9:46 AM