IDEAL INDUSTRIES IZGS 68 ICTX - Manual (Page 18)

18
Possibilities for insertion
Kitchen unit with door
Proper arrangements must be taken
in designing the forniture unit, in order to
avoid any contact with the bottom of the
hob which can be heated when it is
operated. The recommended solution is
shown in Fig. 8. The panel fitted under
the hob should be easily removable to
allow an easy access if a technical
assistance intervention is needed.
a) Removable panel
b) Space for connections
Fig. 8
Fig. 6
Fig.7
Then, place them at 11 mm from the
side edges and at 10 mm from the
rear edge, as shown in Fig. 6, taking
care that the seals meet without
overlapping.
2. Place the hob in the cut out, taking
care that it is centred.
3. Fix the hob with the relevant fixing
clamps, supplied with the injectors
kit (see diagram). When the screws
have been tightened, the excess seal
can be removed.
The edge of the hob forms a double
seal which prevents the ingress of
liquids.
a
a) seal