Intel EPS1U - Manual (Page 29)

SSI
EPS1U Power Supply Design Guide, V1.1
8.4.2.2 MultiRecord Area
As defined by the IPMI FRU document. The following record types shall be used on this power supply:
•
Power Supply Information (Record Type 0x00)
•
DC Output (Record Type 0x01)
•
No other record types are required for the power supply.
MultiRecord information shall be defined as follows:
Table 25: FRU Device MultiRecord Area
Field Name (PS Info) Field Information Definition
Overall Capacity (W) 350 {Low power versions would be 250 or 125}
Peak VA 400 {Low power versions would be 300 or 161}
Inrush current (A) 30
Inrush interval (ms) 5
Low end input voltage
range 1 90
High end input voltage
range 1 140
Low end input voltage
range 2 180
High end input voltage
range 2 264
A/C dropout tol. (ms) 20
Binary flags Set for: Not Hot Swap support, Auto-switch, and PFC
Peak Wattage Set for: 12 s, 400 W {Low power versions would be 300W or 161W}
Combined wattage Set for 5 V & 3.3 V combined wattage of 113 W {Low power versions would be 113W
or 80}
Predictive fail tach
support Not supported, 00h value
Field Name (Output) Field Description: Six outputs are to be defined from #1 to #6, as follows: +3.3 V, +5
V, +12 V1, +12V2, -12 V, and +5 VSB.
Output Information Set for: Standby on +5 VSB, No Standby on all others.
All other output fields Format per IPMI specification, using parameters in the EPS1U specification.