IBM 8306 - Manual (Page 10)

DID YOU RECEIVE THE CORRECT RESPONSE?
If NO, continue to 002 .
If YES, proceed to 003 .
002
If the Power Management feature is enabled, do the following:
1. Start the Configuration/Setup Utility program (see “Setup Utility program” on
page 24)
2. Select Power Management from the Configuration/Setup Utility program
menu.
3. Select APM .
4. Be sure APM BIOS Mode is set to Disabled . If it is not, press Left Arrow (}) or
Right Arrow (Æ) to change the setting.
5. Select Automatic Hardware Power Management .
6. Set Automatic Hardware Power Management to Disabled .
7. If the problem persists, continue to 003 .
003
Run the Diagnostic programs. If necessary, refer to “Diagnostics” on page 26.
v If you receive an error, replace the part that the diagnostic program calls out or
go to ″Symptom-to-FRU Index ″ on page 87.
v If the test stops and you cannot continue, replace the last device tested.
4 Hardware Maintenance Manual