Inter-Tel CS-5400 - Manual (Page 119)

Hardware and Endpoints
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Disconnecting a Headset
Page 101
To connect a headset to all other Inter-Tel phones:
1. Remove the coiled handset cord from the base of the phone. Leave the handset in the
cradle.
2. Insert the headset plug into the vacant handset jack.
3. While on-hook, enter the Headset On feature code (315) or the Headset On/Off feature
code (317). The display shows HEADSET MODE ON.
Disconnecting a Headset
The following procedures describe how to disconnect a headset from an Inter-Tel phone.
To disconnect the headset from a Model 8620 or 8660 IP or a Model 8520 or 8560 digital
phone:
1. Unplug the headset cord from the back of the phone.
2. While on-hook, enter the Headset Off feature code (316) or the Headset On/Off feature
code (317). The display shows HEADSET MODE OFF.
To disconnect the headset from all other Inter-Tel phones:
1. Unplug the headset cord from the base of the phone.
2. Plug the coiled handset cord into the base of the phone.
3. While on-hook, enter the Headset Off feature code (316) or the Headset On/Off feature
code (317). The display shows HEADSET MODE OFF.
Digital Endpoints
With the addition of Digital Expansion Interface (DEI) equipment and appropriate licensing,
the Inter-Tel 5000 Network Communications Solutions platform supports the following digital
phones and endpoints.
•
Hard Digital Phones
— Model 8500
— Model 8520, Two-Line Display
— Model 8560, Six-Line Display
— Associate
— Standard
— Executive
— Professional
— Axxess
®
Basic
— Eclipse
™
Basic
•
Single-Line Adapter (SLA)
•
Single Line Phones
•
Modem Data Port Module (MDPM)
•
Personal Computer Data Port Module (PCDPM), audio only