Inter-Tel CS-5400 - Manual (Page 13)

FCC Regulations
INTER-TEL
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Page ix
FCC Regulations
IMPORTANT
1. This equipment complies with Part 68 of Federal Communications Commission (FCC)
rules. On the side of the equipment chassis is a label that contains, among other infor-
mation, the FCC registration number and ringer equivalence number (REN) for this
equipment. Customers connecting this equipment to the telephone network shall, before
such connection is made, give notice to the telephone company of the particular line(s)
to which such connection is to be made, and shall provide the telephone company with
the following information:
•
Complies with Part 68 of the FCC Rules
•
FCC registration number:
•
USOC numbers of required interface jacks (see chart on next page)
•
Service order code (SOC), as applicable (see chart on next page)
•
Facility interface code (FIC) (see chart on next page)
•
REN, as applicable (see chart on next page)
The telephone company should also be given notice upon final disconnection of this
equipment from the particular line(s).
It is also the responsibility of the customer to provide the telephone company with reg-
istration numbers of any other devices which are configured for connection to the tele-
phone network.
2. This equipment cannot be used on public coin service provided by the telephone com-
pany. Connection to party line service is subject to state tariffs. (Contact the state public
utility commission, public service commission, or corporation commission for informa-
tion.)
3. If this equipment causes harm to the telephone network, the telephone company will
notify the customer in advance that service may be temporarily discontinued. But if
advance notice is not practical, the telephone company will notify the customer as soon
as possible. Also, the customer will be advised of the right to file a complaint with the
FCC, if necessary.
NOTE
The REN is used to determine the number of devices that can be connected
to a single telephone line so that all the devices will ring or otherwise respond
to incoming calls. Each device that can be connected to a telephone line has
a REN value. When the sum of device RENs on a line exceeds the maximum
REN value the line can support, usually 5.0, some or all of the devices may
not ring or respond appropriately. To identify the REN for lines in a telephone
service area, contact the telephone company.