Invacare BAR750 - Manual (Page 23)

SECTION 4—PACKAGING, HANDLING AND SET-UP
Part No 1143215 23 BAR750
8. Pull the head‐end section from the shipping bracket.
9. Remove the clevis pin securing the shipping bracket to foot‐end section from each side
of the foot‐end section. See Detail “D” of FIGURE 4.1.
10. Remove shipping bracket and two cardboard support blocks from foot‐end bed section.
11. Unlock the casters on the foot‐end section.
12. Place power supply cord and handset on top of the bed.
13. Carefully roll the foot‐end section off the pallet.
14. Slide head‐end section into foot‐end section until side frame holes line up. See Detail “E”
of FIGURE 4.1.
CAUTION
Keep power supply cord and handset clear of the gap between the two sections.
15. From the outside of the bed, insert a clevis pin into each side frame hole. Secure clevis
pins using rue rings on inside of frame. See Detail “F” of FIGURE 4.1.
16. Secure the actuators to the frame section using two small clevis pins and two hairpin
clips. See Detail “G” of FIGURE 4.1.
17. Using the hand control, raise the bed to its full height.
18. Remove lock‐pin from support leg located under foot‐end section.
19. Push support leg up and re‐insert lock‐pin. See Detail “H” of FIGURE 4.1.
20. Install the headboard posts in the inward most sockets provided at the head end with
the board closest to the mattress.
21. Install the footboard posts in the inward most sockets provided at the foot end with
the board closest to the mattress.