Invacare BAR750 - Manual (Page 25)

SECTION 4—PACKAGING, HANDLING AND SET-UP
Part No 1143215 25 BAR750
Adjusting the Bed
Adjusting Length
NOTE: For this procedure, refer to
FIGURE 4.2.
1. Pull down on the release knob located
under the head section of the bed. See
Detail “A” of FIGURE 4.2.
2. Pull the length extender out six inches.
3. Release the knob and push the extender
in until the knob locks into place.
NOTE: An audible click will be heard.
4. If necessary, repeat STEPS 1 to 3 for the
foot section. See Detail “B” of
FIGURE 4.2.
FIGURE 4.2 Adjusting the Bed
Adjusting Width
NOTE: For this procedure, refer to
FIGURE 4.3.
1. Pull down on the release knob located
under the side of the bed. See Detail
“A” of FIGURE 4.3.
2. Slide the width extender to one of the
three the desired widths.
3. Release the knob and push on the
extender until the knob locks into
place.
NOTE: An audible click will be heard.
4. Repeat STEPS 1 to 3 for the other four
side sections on that side. See Detail
“B” of FIGURE 4.2.
5. Repeat STPES 1 to 4 for the other side of
the bed.
FIGURE 4.3 Adjusting Width
Length
Extender
Release
Knob
DETAIL “A” - LENGTH EXTENDER
DETAIL “B” - HEAD AND FOOT SECTIONS
Head Section Foot Section
Release
Knob
Width
Extender
Side Sections
DETAIL “A” - WIDTH EXTENDER
DETAIL “B” - SIDE SECTIONS