Ingersoll-Rand PH30F-XXX-XXX-C - Manual (Page 5)

PH30F-XXX-XXX-C (en) Page 5 of 8
) ASSEMBLY TORQUE REQUIREMENTS (
NOTE: DO NOT OVERTIGHTEN FASTENERS.
ALL FASTENERS ARE METRIC.
(14) Cap screw, 65 - 70 ft lbs (88.1 - 94.9 Nm).
(26) Manifold screw, 60 - 70 ft lbs (81.4 - 94.9 Nm).
(27) Fluid cap screw, 60 - 70 ft lbs (81.4 - 94.9 Nm).
(131) Screw, 35 - 40 ft lbs (47.5 - 54.2 Nm).
LUBRICATION / SEALANTS
f Apply Lubriplate FML-2 grease to all “O” rings, “U” cups and mating parts.
g Apply Loctite® 262™ to threads at assembly.
h Apply PTFE tape to threads at assembly.
i Apply Loctite 271™ to threads.
j Apply anti-seize compound to threads and bolt and nut flange heads
which contact pump case when using stainless steel fasteners.
k Apply 1/4” wide x 1/8” thick (aproximately 46” long) expandable PTFE
Joint Sealant to air cap (item 68 only) diaphragm bead groove. Use
ONLY 1 wrap of sealant. DO NOT overlap seam. Fill seam with heavy
duty anaerobic pipe sealant. Seam to be located between bolt positions
1 and 3 (refer to “Torque Sequence” diagram).
Lubriplate FML-2 is a white food grade petroleum grease.
PARTS LIST / PH30F-XXX-XXX-C FLUID SECTION
FOR THE AIR MO-
TOR SECTION, SEE
PAGES 6 & 7.
Torque Sequence
3
2
7
5
1
8
6
4
Figure 2
76
19
78
15a
77
27
19
76
15
22
19
21
22
21
19
61
26
60
26
32
1 5
196 7 6 9
29 69 180 131 3 14
175
144
126
77 68
181 175
70
144
70
View for PH30F-XXX-XXT-C (PTFE diaphragm)
confi guration only.
(Santoprene) 8
(PTFE) 7