Image IMSB53950 - Manual (Page 15)

15
Your spa features an LED light with twelve different
programmed lighting effects:
1. Lights cycle between Red, Green, and Blue
2. Dark Blue
3. Orange
4. Purple
5. Green
6. Red
7. Hot Pink
8. Cyan
9. White
10. Color Spectrum (each color is displayed for
approximately one minute)
11. Blue/Green Mix
12. Party ModeTM (colors cycle rapidly through the
color spectrum)
The light button controlls the LED light. To turn the
light on, press the light button. To turn the light off,
press the light button again. To select the next lighting
effect, turn the light off and then within five seconds
turn it on again. If the light is left off for more than five
seconds, the same lighting effect will be displayed the
next time the light is turned on.
The temperature buttons control the temperature set-
ting of the water. The temperature setting can be from
80°F to 104°F. The startup temperature is set at
100°F. The water heats at about 6°F per hour with the
cover on. Use a medical or other accurate thermome-
ter to check the temperature of the water.
To change the water temperature, press the tempera-
ture up or down button until the desired temperature
is reached. After three seconds, the console will auto-
matically display the last measured water tempera-
ture.
If the temperature sensors detect a drop below 40°F,
then pump 1 (and the heater if necessary) will auto-
matically activate to provide freeze protection. The
equipment will stay on until the sensors detect that
the spa temperature has risen to within 15°F of the
set temperature. Pump 2 and the blower will purge for
30 seconds to 2 minutes at the end of the freeze con-
dition.
The blower button turns the ten air injectors, labeled 5
in the small drawing on page 14, on and off.