Image IMSB53950 - Manual (Page 9)

9
Place all parts of the hydrotherapy spa in a cleared area and remove the packing materials. Do not dispose
of the packing materials until assembly is completed.
Assembly requires your own phillips screwdriver .
1. Before beginning assembly, make sure that you
have read and understand the information above
and on the previous two pages.
Remove the eight #10 x 2” Machine Screws (37) that
secure the indicated Access Panel (25) to the spa.
Carefully remove the Access Panel until the CD wire
harness (not shown) is visible, and disconnect the
CD wire. Set the Access Panel aside.
Be careful
not to damage the spa shell.
Insert the Pillow (38) into the lounge seat receptacle.
Note: The Pillow can be rotated 180º and reattached
in a high or low position.
Assembly
25
37
37
1
38
2. Close the valve knob on the drain hose. Thread the
cap onto the drain hose.
Locate the four gate valves inside the access open-
ing (there are two gate valves per pump). Turn the
gate valves counterclockwise to open them.
Make sure that the six collars are tightened (there
are two collars per pump and two on the heater).
See step 1. Reconnect the CD wire harness to the
CD Player and reattach the Access Panel (25) to the
spa.
Collar
Cap Valve
Knob
Drain
Hose
2
Gate Valve