Integra DPC-6.1 - Manual (Page 10)

10
Connecting the DPC-6.1 to a TV
Here is how to connect your DVD Changer to your TV set. In this case, both the video and audio signals will be
played back by your TV set.
Connecting the DPC-6.1 to a TV
1. Switch of f the DVD Changer and the TV set.
2. Connect the DPC-6.1 to your TV set as shown in the illustration.
■ Selecting the audio outputs
Your DPC-6.1 provides several options for audio playback: you can use the analog or one of the digital audio
outputs. If the audio is to be played back by your TV set, connect the ANALOG OUTPUTs to the audio inputs of your
TV set and activate them (“Analog 2ch”). See “Audio Settings” on page 36 for details.
Notes:
• See also the instruction manual of the connected TV on how to select the signals transmitted by the DVD Changer.
• Before connecting the DVD Changer to your TV, be sure to turn off the power to and unplug both units from the wall outlet.
• If your TV set has one audio input (monaural), connect a Y cable adapter to the DPC-6.1’s ANALOG OUTPUTs, and the other end
of the adapter to the TV’s audio input.
• Be sure to establish a direct video connection between the DPC-6.1 and your TV set. Do not route the video signal through your
VCR or other video component. Otherwise the picture may be distorted due to the DVD video’s copy protection.
COMPONENT
Y P B P R VIDEO S VIDEO
VIDEO OUTPUT
R
L
OPTICAL COAXIAL
DIGITAL
OUTPUT ANALOG
OUTPUT
AC INLET
Do not plug in the
power cable until
all connections
have been made.
Signal flow
To ANALOG
AUDIO OUT
To audio inputs
(white) (r
ed)
Audio/video connection cable
(supplied)
To VIDEO OUT
To S VIDEO OUT
S video cable (supplied)
If the TV has an S video input, connect the DVD
Changer with the supplied S video cable.
To S video input
TV or monitor with
audio and video inputs
(red)
(yellow)
To video input
(yellow) (white)
Improper connection
Insert completely
1. Connect the outlet plug on the included power cable
to the AC INLET on the DPC-6.1.
2. Plug-in the other end of the cable to a wall AC outlet.
Notes:
• Do not use any power cable other than the included cable.
The included cable is designed for use only with the DPC-6.1.
Do not use it for any other device.
• Do not connect or disconnect the outlet plug from the DPC-
6.1 while the other end is plugged into the wall AC outlet.
Connecting a power cable
VIDEO S VIDEO
VIDEO OUTPUT
R
L OPTICAL COAXIAL
DIGITAL
OUTPUT ANALOG
OUTPUT
COMPONENT Y P B P R
AC I NLET
2
1
Power cable
(included)
To wall
outlet
(See below)