InFocus X6 - Manual (Page 35)

 English ...
Appendices
Warning: To avoid
burns, allow the projec-
tor to cool for at least
60 minutes before you
replace the lamp!
Warning: To reduce the
risk of personal injury,
do not drop the lamp
module or touch the
lamp bulb. The bulb
may shatter and cause
injury if it is dropped.
Lamp Replacing Procedure:
1. Switch off the power to the projector by pressing the Power/
Standby .
2. Allow the projector to cool down at least 60 minutes.
3. Disconnect the power cord.
4. Use a screwdriver to remove the screw from the cover. 
5. Push up and remove the cover.
6. Remove the 2 screws from the lamp module  and pull up
the lamp bar. 
7. Pull out the lamp module by force. 
To replace the lamp module, reverse the previous steps.
1
3
4
2