Imperial SHMTM - Manual (Page 5)

PAGE 5
STATIC AND STATIC WITH MOTORIZED DAMPERS MODELS
Installation Kit
Included in the installation kit:
• 4 Collars
• 1 Condensation Drain Line
• 1 Drain Adapter with Nut
• 2 Tie Wraps (30”)
• 16 screws (#10 x 5/8”)
• 4 screws (#10 x 1”)
Figure 3.1 Pull out the inserts first then use the straps to lift the unit out of the box
3. Greentek TM HRV Systems
4. Finding a suitable installation area for HRV.
Figure 3.2 Installation kit is shipped inside the unit Figure 3.3 Installation kit
The HRV unit should be installed in a mechanical room or as close to an outside wall as possible.
This would assure a short run of insulated flexible duct.
The HRV unit must always be installed in an area where the air is tempered to avoid freezing of
the condensate line. The contractor should install the unit in area that is very accessible to allow
the homeowner easy access for maintenance.
You should have access to a condensate drain near the HRV to avoid the use of condensate pump.