Integra DPC-7.4 - Manual (Page 19)

19
Connecting the DPC-7.4 —Continued
With (Remote Interactive) you can control your DPC-7.4
by using the remote controller supplied with your Onkyo or
Integra -compatible
AV receiver.
Notes:
• Push the plugs in all the way to make a good connection.
• Use only cables for connections.
• To use you must also make an analog RCA/phono
connection between your DPC-7.4 and Integra/Onkyo
AV receiver, even if they are connected digitally.
• The DPC-7.4 has two connectors. You can connect
either one to your Integra/Onkyo AV receiver. The other
connector is for connecting additional
-compatible
components.
• Connect the DPC-7.4’s connector to only Integra/
Onkyo AV components. Connecting to other manufac-
turer’s AV components may cause them to malfunction.
• Do not use a power cord other than the one supplied with
the DPC-7.4. The power cord supplied is designed for use
with the DPC-7.4 and should not be used with any other
device.
• Never have the power cord disconnected from the DPC-7.4
while the other end is plugged into the wall outlet. Doing
so may cause an electric shock. Always connect by plug-
ging into the wall outlet last and disconnect by unplugging
from the wall outlet first.
Connecting -compatible AV
Components
MODEL NO. DPC- 7.4 DVD CHANGER
S VIDEO
VIDEO
REMOTE CONTROL
L
R
DIGITAL
OPTICAL COAXIAL
ANALOG
COMPONENT 2
COMPONENT 1
OUT
IN
PB Y PR
PB Y PR
IR
VIDEO OUTPUT
RS 232 AUDIO OUTPUT
AUDIO OUTPUT
Integra/Onkyo AV receiver
REMOTE
CONTROL
L
R
ANALOG
INPUT
DIGITAL IN
OPTICAL
cable
To use you
must make an
analog RCA/phono
connection between
the DPC-7.4 and the
other component
even if they are
connected digitally.
OPTICAL COAXIAL
DIGITAL
OPTICAL COAXIAL
AUDIO OUTPUT
(Supplied)
L
R
ANALOG
AUDIO OUTPUT
REMOTE
CONTROL
Plug the supplied power cord into the AC
INLET
. DPC- 7.4 ANGER
AC INLET