Integra DPC-7.4 - Manual (Page 20)

20
Connecting the DPC-7.4 —Continued
You can use the following multi-room kits to control the
DPC-7.4 when it’s out of range of the remote controller:
• Integra Multi-Room System (IR Remote Controller Exten-
sion System)
• Multiroom AV distribution and control systems such as
those made by Niles ® and Xantech ® .
Controlling the DPC-7.4 When It’s Out of Range
If the DPC-7.4 is located in another room, installed in a cab-
inet, or out of range of its remote controller, you can use a
commercially available IR receiver to pickup the remote con-
troller signals and feed them to the DPC-7.4, as shown below.
Connect the IR receiver to the DPC-7.4 as shown below.
Controlling Other Out-of-range AV Components
If another AV component is out of range of its remote con-
troller, you can use a commercially available IR emitter to
retransmit the remote controller signals received at the DPC-
7.4’s IR IN, as shown below.
Connect the IR emitter to the DPC-7.4’s IR OUT, and place
the IR emitter in front of the other AV component’s remote
control sensor (usually located on its front panel), as shown
below. See the instructions supplied with the IR emitter.
Only remote controller signals received by the DPC-7.4’s IR
IN are fed through to the IR OUT. Signals picked up by the
DPC-7.4’s remote control sensor are not output.
Controlling AV Components that are Out of Range
MODEL NO. DPC- 7.4 DVD CHANGER
S VIDEO
VIDEO
REMOTE CONTROL
L
R
DIGITAL
OPTICAL COAXIAL
ANALOG
COMPONENT 2
COMPONENT 1
OUT
IN
PB Y PR
PB Y PR
IR
VIDEO OUTPUT
RS 232 AUDIO OUTPUT
AUDIO OUTPUT
OUT
IN
IR
IR IN
DPC-7.4
Inside
cabinet
Remote controller
Connecting
block
IR receiver
Signal flow
OUT
IN
IR
DPC-7.4
from connecting block
Miniplug cable
Signal flow
IR IN
IR OUT
Connecting
block
IR receiver
DPC-7.4
IR emitter
Remote controller
Other
component
Signal flow
Signal flow
OUT
IN
IR
DPC-7.4
Remote control
Other component
sensor from connecting block
Miniplug cable
Miniplug
IR emitter
IR Emitter