Invacare Spyder 1098318 - Manual (Page 15)

15
Footrest
Mounting
Pin
ADJUSTING THE FOOTREST
HEIGHT (FIGURE 2)
NOTE: Lay the assembly on a flat surface to simplify this
procedure.
1. Remove the footrest from the wheelchair. Refer to
INSTALLING/REMOVING THE FOOTREST(S) in this
procedure of the manual.
2. Remove impact guards and/or calf strap, if necessary.
3. Remove the hex screw and coved washer and posi-
tion the footrest assembly to a determined height.
4. Lineup the mounting hole in the footrest frame, rein-
sert the hex screw and coved washer; hand-tighten.
5. Tighten the hex screw and coved washer to 80-90-
in./lbs.
6. Repeat this procedure for the other footrest.
7. Replace impact guards and/or calf strap, if necessary.
FIGURE 2 - ADJUSTING THE FOOTREST HEIGHT
Hex Screw
Coved Washer
Footrest
FRONT RIGGINGS PROCEDURE 3
F
R
O
N
T
R
I
G
G
I
N
G
S
FIGURE 1 - INSTALLING/REMOVING THE
FOOTREST(S)
Mounting
Tube
Footrest Release
Lever
INSTALLING/ADJUSTING
ADJUSTABLE ANGLE FLIP-UP
FOOTPLATES
WARNING
When determining the angle of the
footplates, make sure the rear of the
footplates DO NOT interfere with the move-
ment of the front casters.
Installing Hinge (FIGURE 3)
NOTE: This procedure is for individual adjustable angle
footrests only.
1. Position the adjustable angle flip-up footplate (footplate)
hinge on the footrest support tube at the desired height.
2. Position the hardware on the footrest support as shown
in FIGURE 3.
This Procedure includes the following:
Installing/Removing the Footrest(s)
Adjusting the Footrest Height
Installing/Adjusting Adjustable Angle Flip-Up
Footplates
Impact Guards/Optional Calf Strap
Heel Loop Replacement
WARNING
After ANY adjustments, repair or service
and BEFORE use, make sure all attachment
hardware is tightened securely - other-
wise, injury or damage may result.
INSTALLING/REMOVING THE
FOOTREST(S) (FIGURE 1)
NOTE: Remove the footrests from the wheelchair by re-
versing this procedure.
1. Turn the footrest to the side (open footplate is perpen-
dicular to wheelchair).
2. Insert footrest mounting pin into mounting tube.
3. Push the footrest towards the inside of the wheel-
chair until it locks into place.
NOTE: The footplate will be on the inside of the wheelchair
when locked in place.
4. Repeat this procedure for other footrest assembly.
5. To release the footrest, push the footrest release le-
ver inward, rotate footrest outward.
Footrest
INSIDE OF
WHEELCHAIR
OUTSIDE
O F
WHEELCHAIR