Invacare Spyder 1098318 - Manual (Page 19)

19
FIGURE 3 - INSTALLING/REMOVING SEAT
POSITIONING STRAP
Rear Edge of
Seat
Upholstery
NOTE: Only Hook and Loop style seat positioning strap
shown. Auto style seat positioning strap attaches the same
way.
Seat Rail
Rearmost
Mounting
Screws
Seat Positioning
Strap Half
Seat Positioning
Strap Half
INSTALLING/REMOVING SEAT
POSITIONING STRAP (FIGURE 3)
1. Remove seat cushion from wheelchair, if necessary.
2. Remove the REARMOST mounting screws that se-
cure the seat upholstery to the seat rail as shown in
FIGURE 3.
3. Grasp the rear edge of the seat upholstery and lift up
to expose the REARMOST mounting holes in seat
rail.
4. Do one (1) of the following:
A. To install the seat positioning strap, proceed to
STEP 5.
B. Remove the EXISTING seat positioning strap
from the wheelchair.
5. Secure the two (2) halves of the NEW seat position-
ing strap together.
6. Position one (1) end of the NEW seat positioning strap
between the seat upholstery and the seat rail.
7. Align the mounting holes on the seat upholstery, seat
rail, and one (1) end of the NEW seat positioning strap.
8. Secure the NEW seat positioning straps and seat
upholstery to the seat rail with the two (2) mounting
screws. Torque to 25-30 in./lbs.
NOTE: Ensure strap is oriented properly and not twisted
when installing.
9. Repeat STEPS 6-8 for opposite side of the seat posi-
tioning strap.
10. Reinstall seat cushion onto wheelchair, if necessary.
UPHOLSTERY PROCEDURE 4
U
P
H
O
L
S
T
E
R
Y
INSTALLING/REMOVING CHEST
POSITIONING STRAP (FIGURE 4)
1. Remove the two (2) mounting screws and washers
securing the back upholstery to the back cane.
2. Do one (1) of the following:
A. To install the chest positioning strap, proceed to
STEP 3.
B. Remove the two (2) existing chest positioning
strap halves from the back upholstery.
3. Secure the two (2) halves of the NEW chest position-
ing strap together.
4. Align the mounting hole on one (1) end of the NEW
chest positioning strap with the mounting hole on the
back upholstery and back cane.
5. Secure the NEW chest positioning strap and back
upholstery to the back cane with one (1) mounting
screw and washer. Torque to 20-25 in./lbs.
NOTE: Ensure strap is oriented properly and not twisted
when installing.
6. Repeat STEPS 4-5 for opposite side of NEW chest
positioning strap.
FIGURE 4 - INSTALLING/REMOVING CHEST
POSITIONING STRAP
Chest
Positioning
Strap Half
Back
Cane
Back
Upholstery
Mounting
Screws
Washer
Washer
Chest
Positioning
Strap Half
Secure These Ends Together
NOTE: Only Hook and Loop style chest positioning strap
shown. Auto style chest positioning strap attaches the
same way.