Integra DTR-7.4 - Manual (Page 95)

95
Using the Remote Controller with Other Components —Continued
With the Macro function you can program the remote
controller to perform a sequence of actions with one
press of a button. For example, normally you need to
perform the following actions to use a CD player that’s
connected to the DTR-7.4:
1. Press the scroll wheel, (to select AMP mode).
2. Press the On button (to turn on the DTR-7.4).
3. Roll the scroll wheel to select CD (to select the
CD remote controller mode and the CD input
source).
4. 4. Press the Play button (to start the CD
player).
With the Macro function you can program the remote
controller to do all of this with one press of a button.
Making Macros
You can make up to eight macros, and each macro can
perform up to eight actions.
Using Macros
1 Press and hold the Custom button
for more than three seconds.
The remote controller enters Custom
mode.
2 Roll the scroll wheel to select
“MACRO,” and then press the
scroll wheel.
3 Roll the scroll wheel to select
“EDIT,” and then press the scroll
wheel.
4 Roll the scroll wheel to select a
macro, and then press the scroll
wheel.
Macros are numbered from 1 to 8.
Custom
Macro #1 selected
Action #1
5 On the remote controller, press the
buttons whose actions you want to
program into the macro in the
order you want them performed.
To program the CD example in the left
column into a macro: press the scroll
wheel, press the On button, roll the
scroll wheel to select CD, press the
scroll wheel, and then press the Play
button.
Actions are numbered from 1 to 8.
After each button is pressed, “SET” fol-
lowed by “KEY” is displayed.
To add an action that selects an input
source for the main room or Zone 2,
press the Input button or Zone 2 button,
respectively, roll the scroll wheel to
select the input source, and then press
the scroll wheel.
6 When you’ve finished, press the
Macro button.
After the following appears on the dis-
play, the display returns to normal.
Macro #1 selected
8 actions learnt
Macro
Remote Contr
oller