InFocus TD40 NTSC - Manual (Page 27)

Setting the Channel
26 OWNER'S MANUAL
Before your television can begin memorizing the available channels, you must specify the type of signal
source that is connected to the TV (i.e., an antenna, a standard cable system, an HRC, or an IRC).
Press Menu/set button to display the main
OSD menu.
Select the TV main menu item.
Press Menu/Set to enter the sub menu.
Select Channel Type and press VOL+ button
to enter the ¥Š parts. Then the cursor moves
into the ¥Š parts.
Select the channel type with CH+/CH- button
and press BACK button. You can select
AIR, CATV (Cable TV), IRC or HRC.
Press Menu/set button to display the main OSD menu.
Select the TV Main menu.
Press Menu/Set to enter the sub menu.
Select Auto Scan with CH+/CH- button and press
Menu/Set button on the remote control.
Then the tuning bar will appear and scanning will start.
1
2
3
4
5
• You can enter the TV menu in TV mode only.
(When you watch a TV channel.)
Channel Type ¥CATV Š
Auto Scan
Fine Tune
CH ¥CATV 5 Š
Channel Type ¥CATV Š
Auto Scan
Fine Tune
CH ¥CATV 5 Š
1
2
3
4
Auto Scan UHF 16
• Only scanned channels can be stored as Favorite channels.
Channel Type ¥CATV Š
Auto Scan
Fine Tune
CH ¥CATV 5 Š
Channel Type
Auto Scan