Interquartz IQ750 - Manual (Page 9)

9
DATE AND TIME SET UP DISPLAY
The best time to set up the Date and Time is during installation, as follows:
Upon installation the display will automatically show step by step prompts to guide you
through the Date and Time setup procedure. This procedure can also be used at any time
to change the time and date settings.
The following procedure assumes that all steps in the “General Setting Up” have been
carried out.
FIGURE 1A DATE SETTING
1. If the display is blank, lift the Handset briefly to wake up the telephone and replace
the Handset in the cradle
2. For 10 seconds the display will show “20040101” and “DATE-YYYYMMDD” when
the unit is first powered up
3. If the display is alive but not showing “20040101” and “DATE-YYYYMMDD”, press
STORE, TIMER; the display will return to the “20040101” and
“DATE-YYYYMMDD” mode. Proceed to step 4 within the next 10 seconds; repeat
step 3 if necessary to re-enter Date/Time setting mode.
4. Enter Year (4 digits), Month (2 digits) and Date (2 digits)
FIGURE 1B HOUR MODE SETTING
5. Hour Mode Setting - the display will now show “1-12HR 2-24HR”
6. Press 1 for 12 hour mode or 2 for 24 hour mode display (if 24 hour mode was
chosen, please go to step 9)
NEW
REPEAT
CALL#
TIMER
AM
PM
NEW
REPEAT
CALL#
TIMER
AM
PM