Infinity NV30CN - Manual (Page 16)

TROUBLESHOOTING
14
8. Once having removed the brush roll
completely, you will be able to easily
remove the belt from the motor driven
shaft. (Fig. 53)
Fig. 53
9. Slide one end of the new belt over
the drive shaft, and the other end of
the belt around the brush roll. Secure
the left side of the brush roll into
place, and then the right side. Check
to make sure that the belt is
completely centered on the motor
driven shaft and that the brush roll
turns smoothly.
10. Replace the locking clip. Make sure
that the bottom part of the belt is
under the bottom part of the locking
clip.
35
Changing the Headlight
WARNING:
To reduce the risk of electric
shock, the power cord must be
disconnected before performing
maintenance/trouble shooting checks.
Occasionally the headlight will require
changing.
11. To replace the belt and brush roll
cover, lineup the 4 locking tabs on
the belt and brush cover with the
slots on the power nozzle and push
in. (Fig. 54)
12. Rotate the locking screws clockwise
to tighten.
Fig. 54
Fig. 55
Lens Slots
3. Lift out the headlight lens.
4. Remove the light bulb by pulling it out
carefully.
5. Replace the new bulb by pushing it in.
6. To replace the headlight lens, insert
the bottom tabs of the lens into the
holding slots and snap the top back
into place to secure.
1. Turn the vacuum off and unplug from
the electrical outlet.
2. With a flathead screw driver, insert the
end of the screwdriver into the two
slots on top of the headlight lens and
gently pull down. (Fig. 55)
APPRENEZ À CONNAÎTRE VOTRE BALAYEUSE CYCLONIC
VERTICALE
Spécifications Techniques
Voltage : 120V, 60Hz.
Alimentation : 12 A
15. Tuyau Super Extensible
16. Suceur Plat
17. Brosse à Meubles
18. Brosse à Épousseter
19. Support du Boyau Supérieur
20. Bouton d’Ajustement de la Hauteur
du Tube Télescopique
21. Bouton de Dégagement du Bac à
Poussière
22. Support de Dégagement Rapide du
Cordon d’Alimentation
23. Dégagement du Tube Télescopique
24. Support du Cordon d’Alimentation
25. Bouton Marche/Arrêt
26. Port d’Accès
1. Poignée
2. Tube Télescopique
3. Poignée de Transport
4. Bouton de Dégagement de la Porte
Inférieure du Collecteur Cyclone
5. Collecteur Cyclone
6. Bac à Poussière
7. Écran de Débris
8. Lumière d’Indicateur du Filtre
9. Lumière
10. Bouton d’Ajustement de la Hauteur
du Tapis
11. Protège-Meuble
12. Déclencheur de Poignée
13. Sélecteur Tapis-à-Plancher
14. Support du Tube Inférieur
Remarque : * Les illustrations peuvent différer du produit exact.
Fig. 51
7. To remove the worn or broken belt, lift
the brush roll and slide it out. Remove
the brush roll by grasping the left side
of the brush roll and pulling it upward
and out. Once the brush roll has been
pulled out slightly, slip the belt off of it.
(Fig. 51, Fig. 52)
Fig. 52