IGo Direct PPC 6700 - Manual (Page 3)

Installing the Mouse with Macintosh OS X
Before You Begin
¾ Determine that your Macintosh is Bluetooth-enabled with either a built-in
Bluetooth component, or via an external hardware adaptor (Dongle).
¾ Ensure that the accompanying Bluetooth software (Stack) is installed.
¾ It is not necessary to disable or remove your existing mouse
software. (Refer to the User’s Guide included with your Macintosh with
any questions on your current mouse.)
¾ Insert the 2 AAA batteries (included) beneath the battery cover of the
Stowaway Mouse.
Creating a Paired Connection with your Macintosh
1. Install the Bluetooth Dongle, if necessary, and launch the accompanying
Bluetooth Setup Assistant on your Macintosh.
2. Refer to the instructions included with the Bluetooth Setup Assistant on
the process for Pairing Devices.
3. Power on the Stowaway Mouse by switching the Power switch to ON and
press the Discoverable button to make it detectable by the Bluetooth
software on your Macintosh.
4. Begin device detection for the mouse with the Bluetooth Setup Assistant,
and locate the Stowaway Mouse among any found devices.
5. Select the Bluetooth mouse in the list of discovered devices to create a
link to your Macintosh.
6. After the mouse is successfully linked with your Macintosh, the mouse
pointer will immediately begin responding to movement and button
presses, similar to your standard mouse. Refer to the User Guide for your
Macintosh to modify mouse functionality within the Macintosh Operating
System.
Stowaway Bluetooth Mouse Owner’s Manual
Page 3