JVC RX-7022VSL - Manual (Page 23)

20
Adjusting the Subwoofer Output Level
You can adjust the subwoofer output level if you have connected a
subwoofer and set the subwoofer information correctly—“YES.”
On the front panel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1 again.
1
Press ADJUST repeatedly until
“SUBWFR” (with the current setting)*
appears on the display.
* “0” is the initial setting. If you have already changed the
setting, another number (level) will be shown.
2
Press CONTROL UP
5/DOWN ∞ to
adjust the subwoofer output level
(–10 to +10).
From the remote control:
1
Press SOUND.
The 10 keys are activated for sound adjustments.
2
Press SUBWOOFER +/– to adjust
the subwoofer output level
(–10 to +10).
Note:
Subwoofer output level cannot be adjusted when using headphones.
Reinforcing the Bass
You can boost the bass level.
Press BASS BOOST on the front panel or on the
remote control to select the bass boost function.
• Each time you press the button, the bass boost function turns
on (“BASSBOOST ON”) and off (“BASSBOOST OFF”).
– Select “BASSBOOST ON” to activate the bass boost function.
The BASS BOOST indicator lights up on the display.
– Select “BASSBOOST OFF” to cancel it.
The indicator goes off.
Note:
This function affects the front speaker sounds only.
BASS BOOST
From the remote control On the front panel
BASS BOOST
L C
S.WFR
LS RS
CH-
S
LFE
SPK
DIGITAL AUTO
LINEAR PCM
1
R
Adjusting the Tone
You can adjust the bass and treble sounds as you like.
On the front panel:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1 again.
1
Press ADJUST repeatedly until “BASS”
or “TREBLE” (with the current
setting)* appears on the display.
* “0” is the initial setting. If you have already changed the
setting, another number (level) will be shown.
BASS : To adjust the bass.
TREBLE : To adjust the treble.
2
Press CONTROL UP
5/DOWN ∞ to
adjust the bass or treble sounds level
(–10 to +10).
• Each time you press the button, the sound
level changes by ±2 steps.
From the remote control:
1
Press BASS +/– or TREBLE +/– to
adjust the bass or treble sounds
level (–10 to +10).
• Each time you press the button, the sound
level changes by ±2 steps.
CONTROL
DOWN UP
BASS − +
CONTROL
DOWN UP
SOUND
TREBLE − +
0 +10
FM MODE 100+
– SUB WOOFER +
L C
S.WFR
LS RS
CH-
S
LFE
SPK
DIGITAL AUTO
LINEAR PCM
1
R
ADJUST SETTING
ADJUST SETTING
EN10-22.RX-7020V[A]3 02.4.17, 5:16 PM 20