JVC RX-7022VSL - Manual (Page 25)

22
4
Press MEMORY again while the
selected channel number is flashing
on the display.
The selected channel number stops flashing.
The station is assigned to the selected channel number.
5
Repeat steps 1 to 4 until you store all the stations
you want.
To erase a stored preset station
Storing a new station on a used number erases the previously stored
one.
To tune in a preset station
On the front panel:
1
Press FM/AM to select the band
FM or AM.
The last received station of the selected band is
tuned in.
• Each time you press the button, the band alternates between
FM and AM.
2
Press FM/AM PRESET 5/∞
repeatedly until you find the channel
you want.
• Pressing FM/AM PRESET 5 increases the
channel numbers.
• Pressing FM/AM PRESET ∞ decreases the
channel numbers.
From the remote control:
1
Press FM/AM to select the band
FM or AM.
The last received station of the selected band is
tuned in and the 10 keys now work for tuner operation.
• Each time you press the button, the band alternates between
FM and AM.
2
Press 10 keys to select a preset
channel number.
• For channel number 5, press 5.
• For channel number 15, press +10 then 5.
• For channel number 20, press +10 then 10.
• For channel number 30, press +10, +10,
then 10.
Note:
When you use 10 keys on the remote control, be sure that they are
activated for the tuner, not for the CD and others. (See page 34).
FM/AM
FM/AM PRESET
L C
S.WFR
LS RS
CH-
S
LFE
SPK AUTO MUTING TUNED STEREO
VOLUME
ANALOG 1
R
MEMORY
L C
S.WFR
LS RS
CH-
S
LFE
SPK AUTO MUTING TUNED STEREO
VOLUME
ANALOG 1
R
FM/AM
2 3 1
5 6 4
8 9 7 / P
0 +10 10
EFFECT
TEST
RETURN FM MODE 100+
– SUB WOOFER +
– REAR • R +
– REAR • L +
– CENTER +
MENU
ENTER
Selecting the FM Reception Mode
When an FM stereo broadcast is hard to receive or noisy, you can
change the FM reception mode while receiving an FM broadcast.
• You can store the FM reception mode for each preset station. (See
page 21).
1
While listening to an FM station, press FM
MODE.
• Each time you press the button, the FM reception mode
alternates between “AUTO*” and “MONO.”
* “AUTO” is the initial setting.
AUTO : Normally select this.
When a program is broadcasted in stereo, you will
hear stereo sound; when in monaural, you will
hear monaural sounds. This mode is also useful to
suppress static noise between stations. The AUTO
MUTING indicator lights up on the display.
MONO : Select this to improve the reception (but stereo
effect will be lost).
In this mode, you will hear noise while tuning into
the stations. The AUTO MUTING indicator goes
off from the display. (The STEREO indicator also
goes off.)
FM MODE
On the front panel From the remote control
0
FM MODE
– SUB WOOFER +
L C
S.WFR
LS RS
CH-
S
LFE
SPK AUTO MUTING TUNED STEREO ANALOG 1
R
L C
S.WFR
LS RS
CH-
S
LFE
SPK TUNED ANALOG 1
R
EN10-22.RX-7020V[A]3 02.4.17, 5:16 PM 22