Jensen JMC-326 - Manual (Page 13)

12
ii. If “Wake to CD” alarm mode is selected, make sure that there is a disc loaded in the Disc 1 CD
compartment and the volume is set to a comfortable level prior to going to sleep.
IMPORTANT: Disc 2 player will not operate in “Wake To CD” alarm mode.
iii. In
“Wake to CD” alarm mode, the maximum playable time is 60 minutes. For CDs with total
playing time less than 60 minutes, playback will stop when the last track on the CD has been
played even though the alarm duration time has not elapsed.
SNOOZE OPERATION
1.
!
When the alarm sounds (alarm, radio or CD), you can press the SNOOZE Button to extend the
alarm time by 9 minutes. The ALARM, RADIO or CD will then turn on again.
2. The SNOOZE operation can be repeated several times within the 60 minutes alarm duration until
the BUTTON is pressed.
SLEEP TIMER OPERATION
You can use the SLEEP Timer to fall asleep listening to the Radio or CD for 10 to 90 minutes.
SLEEP OPERATION
1. In Power On mode, operate the Radio or CD as usual. Adjust the volume to the desired level.
Note: The level you selected for “Sleep to Music” is the same level you will hear when the alarm
turns “On”.
2. Press the SLEEP button. The SLEEP Icon (D6) appears in the LCD Display. The Display will
show 90 minutes of playing time and then return to show the current function mode in 5
seconds.
The Music System will automatically turn off after 90 minutes has elapsed.
3. To cancel the SLEEP function, press the SLEEP Button again. The SLEEP Indicator (D6) will
disappear from the LCD Display.
ADJUSTING THE SLEEP TIME
1. With the unit In POWER ON mode, press the SLEEP Button repeatedly to select the desired
amount of sleep time. With each press of the button the sleep time decreases by 10 minutes.
2. The unit will automatically turn off after the preset sleep time has elapsed. However, if you want
to turn the radio off before the preset sleep time has elapsed, press the Button once to switch
the power off. The LCD Display will revert to show the current time
Note: If 90 or 60 minutes sleep time is selected and you are playing a CD that is only 48 minutes long,
for example, playback will stop at the end of the disc.
SLEEP AND WAKE TO ALARM/CD/RADIO
1. Follow steps 1 to 4 (shown in P.6) under the “SETTING ALARM TIME” section to set the ALARM
time.
2. Set your desired “WAKE TO” source as describe above in the “ALARM OPERATION” section.
Follow step 1 (shown above) under the “ADJUSTING THE SLEEP PERIOD” section to set the
desired SLEEP time.
The Music System is now programmed to turn off automatically at the Sleep Time you selected and
then to turn on again at the preset “Alarm Time”.