Jensen JMC-326 User Manual
Page 8
7
OPERATING INSTRUCTIONS
1.
The clock has to be set the first time you use the unit. If power interruption occurs you will
need to reset the clock.
2.
Use the buttons on the REMOTE CONTROL when following the instructions and set-up
procedures found in this manual. Some of the features may also be accessed by the buttons
on the main unit, but not all.
Note: Steps in the instructions marked with this icon
!
are tasks that can only be performed by
using the controls on the main unit.
SETTING ALARM AND CURRENT TIME
1. Press and hold the PROG/SET Button until the ALARM Indicator (D11) appears in the top
left-hand corner of the Display. The HOUR Digit is flashing.
2. While the HOUR Digit flashes, repeatedly press the
"
or
#
Buttons until the desired hour
appears in the Display.
Note: Make sure the hour is set so that AM or PM is correctly displayed. It is important that the “AM”
or “PM” setting is correct for proper operation of the Alarm function. If the PM indicator is 'On',
the time displayed is "PM". If the PM indicator is 'Off, the time displayed is "AM ".
3. Press
the
PROG/SET Button to confirm the setting. MINUTE Digit will now flash.
4. While the MINUTE Digit flashes, repeatedly press the
"
or
#
Buttons until the desired minute
appears in the Display.
5. Press
the
PROG/SET Button to confirm the setting. The ALARM Indicator (D7) disappears and
the Display reverts to current time with the HOUR digit flashing.
6. Repeat procedure # 2 - # 5 to set the correct current time.
Note: Make sure the hour is set so that AM or PM is correctly displayed. It is important that the “AM”
or “PM” setting is correct for proper operation of the Alarm function.
LISTENING TO THE RADIO
Note: i. Your System defaults to FM mode.
ii. You can store up to 20 AM and 20 FM preset stations.
Press once to turn the System on. The LCD backlight lights up and the FM frequency reading
appears in the Display.
TO: PRESS:
Toggle between AM and FM band
STOP/BAND
repeatedly
Scan radio station automatically
#
or
"
for 1 second then release
Stop auto-tuning
#
or
"
again
Scan radio station manually
#
or
"
repeatedly
Control the volume
VOL
▲/▼
Note:
1. When using the FM radio be sure to fully extend the wire antenna to insure maximum tuner
reception.