Jack Lananne's Power Juicer power juicer - Manual (Page 10)

Assembly
STEP
1
:
Remove pusher from chute. Insert
the E-Z Loader Attachment into the
chute lining up the flat side of the
container base to the flat side of
the chute. Secure attachment.
• TO AVOID PERSONAL INJURY: Never look inside the chute while the machine
is running. Especially when using fruits or vegetables that contain pits. Shut down
the machine and wait for the blade to stop spinning. Remove power cords from
electrical outlet before removing the pits from the chute.
• When using the E-Z Loader Attachment with fruits or vegetables that have pits
such as cherries always replace the E-Z Plug in the bottom of the container to
avoid pits from bouncing out of the chute.
• When juicing you must remove the cherry pits from the chute once the juice
has been extracted. Shut the power off and wait for blade to stop spinning before
disassembling the machine to remove the pits.
E-Z Loader Attachment
STEP
2
:
Insert the clear, E-Z Plug into the
opening at the bottom of the
container. Pull the string up over
the top of the container (as shown).
Load ingredients.
Note: When not using E-Z Loader
Attachment replace with pusher.
Important Safety Information
READ THESE SAFEGUARDS CAREFULLY
BEFORE USING YOUR E-Z LOADER ATTACHMENT!
POWER JUICER ELITE