JVC TH-A85 - Manual (Page 30)

27
Tuner operations
You can browse through all the stations or use the preset function to
go immediately to a particular station.
IMPORTANT
Before using the remote control for the following
operation;
1 Set the remote control mode selector to
AUDIO.
2 Press FM/AM.
On the remote control:
1
Press FM/AM repeatedly to select the
band.
Each time you press the button, the band alternates between
FM and AM (MW).
The selected band appears on the display window, then the last
received station appears.
Example: When AM is selected
2
Press TUNING ª or TUNING ·
repeatedly until you find the frequency
you want.
When you hold down the button until the system starts
searching for stations and then release it, the system stops
searching automatically when a station of sufficient signal
strength is tuned in to.
• TUNING ª: Increases frequency.
• TUNING ·: Decreases frequency.
NOTE
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights on the display window.
• When an FM stereo program is received, the ST indicator lights on the
display window.
Once a station is assigned to a channel number, the station can be
quickly tuned in. You can preset 30 FM and 15 AM (MW) stations.
7 To preset the stations
NOTE
Before you start operation;
• There is a time limit when doing the following steps. If the setting is
cancelled before you finish, start from step 2 again.
1
Tune in the station you want to preset.
• For the detailed procedure, see “Manual tuning”.
• If you want to store the FM reception mode for an FM
station, select the reception mode you want. See “Selecting
the FM reception mode” (
A pg. 28).
Number buttons
Remote control
mode selector
Manual tuning
Preset tuning
After a few seconds
TH-A85-55[B]-06Tuner.fm Page 27 Wednesday, April 2, 2003 1:08 PM