Jensen JTA-475 - Manual (Page 13)

13
7.) Press the STOP button to stop programmed tracks playback. Press the
PLAY/PAUSE button will resume normal playback.
NOTE: If you press or SKIP/SEARCH buttons during programmed playback,
the player will skip forward or backward to the next track that was programmed, and not
to the next track in sequence on the disc that is being played.
REPEAT Playback
This system has a repeat function which allows you to continuously repeat one track, or
all tracks.
Select the track to be repeated and begin playback. Press the REPEAT button, “Repeat
1” indicator will light on the display and the selected track will be repeated
continuously. Press the REPEAT button again, “Repeat All” indicator will light on,
the entire track will be repeated continuously. Press REPEAT button until the “Repeat”
indicator disappears to resume to normal playback.
RANDOM Playback
Press the RANDOM button before or during playback, “RAN.” indicator will light on the
display. Then, all the tracks in the CD will be played in random order. Switch off random
playback function by pressing the RANDOM button again and the “RAN.” indicator will
go out.
REPEAT/RANDOM Playback by Remote Control
Press the REPEAT/RANDOM button on the remote control before or during playback,
REPEAT and RANDOM function will switch as the below sequence:
REPEAT 1 REPEAT ALL RANDOM REPEAT/RANDOM OFF
STEREO PHONOGRAPH OPERATION
NOTE, BEFORE USE:
-
Remove the stylus protector.
- Be sure that the tone arm is detached from the tone arm
rest before operating, and replace again when finished.
1.) Press down the POWER button to turn the system "On".
2.) Slide the FUNCTION selector to the PHONO position.
3.) Raise the turntable dust cover.
4.) Release the tone arm clamp and remove the stylus protector.
5.) Place a record on the platter, over the center spindle (use the 45 RPM record adaptor
when playing 45 RPM record).