Jensen JTA-475 - Manual (Page 14)

14
6.) Set the Speed selector to 33, 45 or 78 rpm according to the record you are playing.
7.) Lift the tone arm from the rest and slowly move it over the record. The platter will
being to turn.
8.) Move the tone arm to the beginning of the record, or to the start of
a particular track. Gently lower the tone arm onto the record to start
playing.
9.) Press and hold the VOLUME+/- buttons to adjust volume level
as desired.
10.) When the record is played to the end of the record, the platter will automatically stop
rotating. Lift the tone arm and return it to the rest position.
11.) To stop the record manually when playing, lift up the tone arm and return it to the
rest position.
REMARK: Some types of records may have an auto-stop area outside the preset limit,
so the turntable may stop before the last track finishes. In this case, set the auto-stop
switch to the “OFF” position. This allows the record to play to the end, but it will not stop
automatically. You must manually raise the tone arm and place it back in the rest to stop
the turntable from spinning and turn it off.
CASSETTE TAPE OPERATION
1.) Press down the POWER button to turn the system "On".
2.) Slide the FUNCTION selector to the TAPE position.
3.) The system will start playback automatically after inserting
the cassette tape.
4.) Press and hold the VOLUME+/- buttons to adjust volume level as desired.
5.) Press the TAPE FAST FORWARD / EJECT button half way when playing, the tape
will be advanced forward rapidly.
6.) Slightly press the TAPE FAST FORWARD / EJECT button again to resume normal
playback. The button will resume to the outermost position.
7.) Press the TAPE FAST FORWARD / EJECT button completely, then the playing will
be stopped and the cassette tape will be ejected.
REMARK:
Make sure the direction is correct when inserting the tape.