JVC CA-UXH35 - Manual (Page 10)

7
1 Connect the AM loop antenna to the
AM LOOP terminals as illustrated.
2 Turn the AM loop antenna until you
have the best reception.
To connect an outdoor AM (MW) antenna
When reception is poor, connect a single vinyl-covered
wire to the AM EXT terminal and extend it
horizontally. The AM loop antenna must remain
connected.
For better reception of both FM and AM (MW)
• Make sure the antenna conductors do not touch any other
terminals and connecting cords.
• Keep the antennas away from metallic parts of the unit,
connecting cords, and the power cord.
AM (MW) antenna
Vinyl-covered wire
(not supplied)
AM loop antenna
(supplied)
1
2
Connecting Speakers
1 Press and hold the clamp of the
speaker terminal on the rear of the
unit.
2 Insert the end of the speaker cord into
the terminal.
Match the polarity between the unit and the
speaker terminals:
ª to ª and · to ·.
3 Release your finger from the clamp.
• DO NOT connect speakers while the
power is on.
• DO NOT connect more than one speaker
to each speaker teminal.
IMPORTANT: Use only speakers with the same
speaker impedance as shown on the speaker
terminals on the rear of the unit.
Speaker cord
Speaker cord
Right speaker Left speaker
1 2
EN01-15_UX-H30[B]f.pm6 02.12.26, 1:35 PM 7