JVC CA-UXH35 - Manual (Page 26)

23
4
Select the timer (Daily
Timer or Recording Timer)
with the source to play.
On the remote control:
Press
UP or DOWN to
select the timer, then press
CLOCK/TIMER.
On the unit:
Press
¢ or 4 to select the
timer, then press TIMER/SNOOZE.
• Each time you press UP
( ¢) or DOWN (4), the
timer mode and the source
change as follows:
TUNER : tunes in to the last station you were
listening to. (Daily Timer)
REC TUNER : records the last station you were
listening to. (Recording Timer)
• Put a recordable cassette into the deck.
CD : plays a disc. (Daily Timer)
• Load a disc.
TAPE : plays a tape. (Daily Timer)
• Make sure that the tape is in the cassette
deck.
• Make sure that the tape direction is
correct.
The unit enters the volume level setting mode.
5
Select the volume level.
On the remote control:
Press
UP or DOWN to set the volume level,
then press CLOCK/TIMER.
On the unit:
Press
¢ or 4 to set the volume level, then
press TIMER/SNOOZE.
• You can select the volume level
(“VOLUME – –” and “VOLUME 0” to
“VOLUME 40”).
If you select “VOLUME – –,” the volume is set
to the previous level when the unit was turned
off.
• To turn off the volume while the Recording
Timer ( REC TUNER) is working, set the volume
level “VOLUME 0.”
The unit enters the clock setting mode.
TUNER TUNER
REC
CD TAPE
6
Adjust the clock if you need.
• See “Setting the Clock” on page 10.
7
Press STANDBY/ON
(or
on the unit) to turn
off the unit (standby) if you
have set the timer with the
unit turned on.
• When the timer turns on the unit, the (timer)
indicator starts flashing. (If the Recording Timer
is selected in step 4, the REC indicator also
starts flashing.)
To deactivate the timer temporarily,
press and hold CLOCK/TIMER (or
TIMER/SNOOZE on the unit) until
the
(timer) indicator on the display
goes off.
To activate or change the timer
(with the previous setting), follow
steps 1 to 7 on pages 22 and 23.
• If you want to change the timer setting after the
Daily Timer be used, first deactivate the timer.
• If the unit is turned on when the timer on-time comes
Timer does not work.
• When you unplug the power cord or if a power failure
occurs
The timer will be canceled. You need to set the clock first,
then the timer again.
STANDBY/ON
UP
DOWN
CLOCK
/ TIMER
TIMER/SNOOZE
CLOCK
/ TIMER
TIMER/SNOOZE
EN20-28_UX-H30[B]f.pm6 02.12.26, 1:38 PM 23