JBL CS3 - Manual (Page 30)

• Remember to press the appropriate Input Selector 0 button
before functions are changed to another device.
3. When all the steps have been entered, press the M N KL
9 button to enter the commands. The red light under the
Input Selector
0 will blink and then turn off and the Program
Indicator e will flash green twice, to confirm the macro to be
programmed.
Example: To program the Macro 1 K button so that it turns on the
CS3/CS5 and your TV, follow these steps:
• Press the Macro 1 K and Mute A buttons at the same time and
then release them.
• Note that the Program Indicator e will flash amber.
• Press the TV Selector
0.
• Press the Mute A button to store the CS’s power on command.
• Press the Screen Power On Y button to store the TV Power On
Command.
• Press the M N KL Channel Up 9 button to complete the
process and store the macro sequence.
After following these steps, each time you press the Macro 1 K
button, the remote will send all Power On commands.
Erasing Macro Commands
To remove the commands that have been programmed into one of
the Macro buttons, follow these steps:
1. Press the Mute Button A and the Macro Button K that
contains the commands you wish to erase.
2. Note that the Program Indicator e will flash amber, and the red
LED under the Input Selector 0 last used will turn on.
3. Within ten seconds, press the Mute Button A.
4. The red LED under the Selector will go out, and the Program
Indicator e will turn green and flash three times before it
goes out.
5. When the Program Indicator e goes out, the Macro has been
erased.
30
LEARNING CODES FROM A REMOTE CONTROL