Jwin JX-DVD400 - Manual (Page 33)

7.Function Buttons
7.1 Function Buttons on the Front Panel
This section instructs you the basics on how to operate
the player.
After connection, you must make the following preparations
before operation of this player.
* Turn on the TV and select Video Input.
* Connect the power wires of the player to the socket.
(the functions list below also corresponds to the button
functions of the remote control)
7.1.3 Play
Press the button to close the disc tray and start playback.
7.1.2 Standby
Press the button for the first time and the player will be in
standby state and reduce the power consumption. Press this
button again and the player will recover operation.
7.1.4 PAUSE
7.1.1 Power
Press the button to switch the unit ON/OFF.(the button is
located at the rear panel)
16
Press the PAUSE button to pause playback(still mode).
But on the remote control ,you press the button once,the player
will be in pause state; you press the button twice, the picture
will advances frame by frame. To resume normal playback,
press the PLAY button.