John Lewis JLDWW 1206 - Manual (Page 20)

Set the washing programme, delay
start and half load with the dishwasher
door slightly open.
The selection can also occur with the
door closed. Keep in mind that this
way you have ONLY 3 seconds
between one selection and another,
after which the washing programme
will start automatically.
3. Switch on the dishwasher. The appliance
must be in setting mode: message
CHOOSE PROGRAMME displayed.
4. Select the washing programme by
pressing one of the programme scrolling
buttons.
If a button is pressed only once, the last
performed washing programme will be
proposed.
5. If required, postpone the start time of the
washing programme by using the delay
start option. The start of the washing
programme can be delayed for between 1
and 19 hours.
6. Close the dishwasher door, the
programme starts automatically. Once
the programme is running the display
shows:
– the phases of the progress of the
programme,
– updates the running time of the
programme.
7. If the start of the programme has been
postponed, the countdown will start
automatically once the dishwasher door is
closed.
The countdown will decrease in steps of
1 hour.
Opening the door will interrupt the
countdown. Close the door; the
countdown will continue from the point at
which it was interrupted.
Once the delay start has elapsed the
programme will start automatically.
If during the progress of the delay start
or the running of the washing
programme you wish to see which
programme has been set or is
performing; press one of the
programme scrolling buttons. The
name of the programme will appear
for a few seconds in the display.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it’s absolutely
necessary. Attention! Hot steam
may escape when the door is
opened. Open the door carefully.
Cancelling a delay start or
a washing programme in
progress
• To cancel a washing programme or a delay
start in progress you have to reset the
appliance.
Cancelling a delay start will also cancel
a washing programme. You have to set
the washing programme again.
• Simultaneously press and hold the two
buttons positioned over the word Cancel
until the message CHOOSE
PROGRAMME appears on the display.
The washing programme or the delay start
has been cancelled.
• If a new washing programme is to be
selected, check that there is detergent in
the detergent dispenser.
20