Select the tv system, Start auto channel set, Attention – JVC LPT0762-001B User Manual

Page 17

Advertising
background image

Masterpage:Right-No-Heading

EN

17

Filename [XVS20AA_06Index.fm]

Page 17

April 10, 2003 4:49 pm

E

Select the TV system.

Press

rt to place the pointer next to the appropriate TV

system (refer to the table below).

F

Start Auto Channel Set

Press OK or

e.

● Receivable channels in your area are automatically assigned to

the PR +/– buttons, and non-receivable channels are skipped.

● As Auto Set Up progresses, the

q” mark on the TV screen moves

from left to right.

● When Auto Set Up is completed,

the lowest position number will
appear on the front display
panel. If “SCAN COMPLETED –
NO SIGNAL–” is displayed on
the TV screen, make sure that the
aerial cable is connected to the unit properly and press OK on
the remote control. The unit will try Auto Set Up again.

NOTES:

● If there is a power cut, or if you press 1 or SET UP MENU

while Auto Set Up is in progress, Auto Set Up will be
interrupted; be sure to turn off the unit power once and try
again from step

A.

● If no sound accompanies the picture or the audio sounds

unnatural on some channels that have been stored by Auto Set
Up, the TV system setting for those channels may be incorrect.
Select the appropriate TV system for those channels.
(

pg. 86, “TV System Selection — When you see the picture

but the audio can’t be heard or sounds unnatural”)

Major Countries/Areas

TV System

Australia, New Zealand, Kuwait, U.A.E.,
Indonesia, Singapore, Thailand,
Malaysia, Iran, Saudi Arabia, Egypt,
Morocco, Lebanon, Iraq

B/G

China, Mongolia, Russia

D/K

Hong Kong

I

DO NOT press any button on the unit or remote control
while Auto Set Up is in progress.

AUTO CH SET

PLEASE WAIT

START

FINISH

– – – – – – –

ATTENTION

If you perform Auto Set Up successfully during installation,
there's no need to separately perform the Clock Set or
Channel Set procedures, but if adjustments become
necessary, they can be performed as follows:

● Tuner setting

pg. 83

● Clock setting

pg. 87

After “Auto Set Up” is completed, perform “Monitor
Set (DVD deck)” on page 18.

XVS20AA_06Index.fm Page 17 Thursday, April 10, 2003 4:52 PM

Advertising
This manual is related to the following products: