JVC LPT0762-001B - Manual (Page 94)

Filename [XVS20AG_11Trouble.fm]
Masterpage:Left+
94
EN
Page 94 April 9, 2003 10:50 am
TROUBLESHOOTING (cont.)
OTHER PROBLEMS
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. The image of TV broadcast appears
distorted on the TV screen.
● The unit leaves turned on and the DVD
deck is selected.
Turn off the unit, or press S-VHS to select
the S-VHS deck, then press TV/VCR so
that the VCR indicator disappears from the
front display panel.
2. Whistling or howling is heard from the
TV during camcorder recording.
● The camcorder’s microphone is too
close to the TV.
Position the camcorder so its microphone
is away from the TV.
● The TV’s volume is too high. Turn the TV’s volume down.
3. When scanning channels, some of
them are skipped over.
● Those channels have been designated to
be skipped.
If you need the skipped channels, restore
them. (
੬
pg. 85)
4. The channel cannot be changed. ● Recording is in progress. Press 9 to pause the recording, change
channels, then press 4 to resume
recording.
5. Channel settings that were made
manually seem to have changed or
disappeared.
● After the manual settings were made,
Auto Channel Set was performed.
Perform manual setting again.
6. No channels are stored in the unit’s
memory.
● The TV aerial cable was not connected
to the unit when Auto Set Up was
performed.
Turn off the unit once and connect the TV
aerial cable to the unit properly, then turn
on the unit again. Then perform Auto Set
Up again. (
੬
pg. 16)
ATTENTION
This unit contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch the
unit off and unplug the mains power cord. Then plug it in again and turn the unit on. Take out the cassette. After checking the
cassette, operate the unit as usual.
XVS20AG_01.book Page 94 Wednesday, April 9, 2003 10:53 AM