JVC GR-D201 - Manual (Page 72)

72
EN
Master Page: Left
Other problems
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
24. The POWER/CHARGE lamp
on the camcorder does not
light when the charging is
attempted.
24. • The temperature of the
battery is extremely high/
low.
• Charging is difficult in places
subject to extremely high/
low temperatures.
24. • To protect the battery, it is
recommended to charge it in
places with a temperature of
10°C to 35°C. (
੬ pg. 74)
25. “SET DATE/TIME!” appears. 25. • The built-in clock’s
rechargeable lithium battery
is discharged.
• The previously set date/time
is erased.
25. • Connect the camcorder to an
AC outlet using the AC
Adapter for over 24 hours to
charge the clock’s lithium
battery. (
੬ pg. 14)
26. There is no picture. 26. • The camcorder is not getting
power, or some other
malfunction exists.
26. • Turn the camcorder’s power
off and on again. ( ੬ pg. 13)
27. Some functions are not
available using the MENU
button.
27. • The Power Switch is set to
“A”.
27. • Set the Power Switch to “M”.
( ੬ pg. 13)
28. Files stored in the memory
card cannot be deleted.
28. • Files stored in the memory
card are protected.
28. • Remove protection from the
files stored in the memory
card and delete them.
(
੬ pg. 27 –28)
29. When the image is printed
from the printer, a black bar
appears at the bottom of the
screen.
29. • This is not a malfunction. 29. • By recording with “DIS”
activated ( ੬ pg. 31, 36) this
can be avoided.
30. When the camcorder is
connected via the DV
connector, the camcorder does
not operate.
30. • The DV cable was plugged/
unplugged with power
turned on.
30. • Turn the camcorder’s power
off and on again, then
operate it.
31. The rear of the LCD monitor is
hot.
31. • The light used to illuminate
the LCD monitor causes it to
become hot.
31. • Close the LCD monitor to
turn it off or set the Power
Switch to “OFF”, and let the
unit cool down.
32. Images on the LCD monitor
appear dark or whitish.
32. • In places subject to low
temperature, images become
dark due to the
characteristics of the LCD
monitor. When this happens,
the displayed colour s differ
from those that are actually
recorded. This is not a defect
of the camcorder.
• When the LCD monitor’s
fluorescent light reaches the
end of its service life, images
on the LCD monitor become
dark. Consult your nearest
JVC dealer.
32. • Adjust the brightness and
angle of the LCD monitor.
(
੬ pg. 12, 13)
GR-D200PAL.book Page 72 Monday, June 30, 2003 6:10 PM