Jacuzzi HE96000 - Manual (Page 12)

Comfort PLUS Whirlpool Bath
Page 12 www.jacuzzi.com Installation and Operation
English
10
Inspect all fittings, plumbing, and control lines
after inserting to insure the components are not
damaged, disconnected, or contacting the finish
surface substrate or support members.
11 Align the bathtub and connect the drain.
12
Turn on the power supply to the dedicated GFCI
protected circuits and check system operation.
13
Caulk around the perimeter of bathtub to seal the
space between the rim and the finished deck.
Drop-in Installation (con’t)
3-Wall Alcove Installation
1
Install the drain/overflow according to the
manufacturer’s instructions. Refer also to the
Technical Specifications Manual.
Watertight installation of the drain is the installer’s
responsibility. Drain leakage is excluded from the
Jacuzzi Luxury Bath warranty of this product.
2
Install the faucet at this time. It is recommended that
the faucet be installed by a qualified plumber.
3
Install the flange (purchased separately) according
to the instructions that are included with the kit. If the
bathtub is equipped with an integrated flange, skip this
step.
4
Turn off the power supply to the GFCI protected
circuit.
5 Insulation may be placed within the bathtub surround,
except around the motor/pump.
6 Connect flex water supply lines to faucet and plug
power cords into GFCI outlet.
7 Place the bathtub into the niche. Screw the flange to
the wood stud. It may be necessary to shim the unit
to close up any gaps between the wood stud and the
flange.
8 Align the bathtub and connect the drain.
9
Inspect all fittings, plumbing, and control lines after
inserting the bathtub to insure the components are
not damaged, disconnected, or contacting the finish
surface substrate or support members.
10
Turn on the power supply to the dedicated GFCI
protected circuits and check system operation.
11
Complete all finish work around the perimeter of
bathtub to seal the space between the rim and the
finished deck.
Screw
Tile Flange
Tile
Cement Board
Caulking
Stud Wall
Tile Adhesive
Stud
Mounting
Screw
1˝ x 4˝
(not for
support)
Tile Flange
Silicon/Sealant
Bath Rim
Plastic Filler
Cement Board
Mortar
Stud Wall
1˝ x 4˝ (not for
support)
Finishing
Material
Figure 7
Figure 8
Figure 9