Jacuzzi HE96000 - Manual (Page 25)

Comfort PLUS Whirlpool Bath
Installation and Operation www.jacuzzi.com Page 25
English
Roughing-In Reference - Corner
SUPPORT FOR CORNER BATHS
H
2" x 4" STUD
APPLY
ADHESIVE
*Add ¼˝ (6mm) to this dimension when roughing-in for 3-wall niche.
1. The overall dimensions are nominal with a tolerance of +0 and -¼˝ (6mm).
2. Service Access dimensions given are minimum. Service access is still required for units that do not have pre-installed Pump/Motor.
3. Measurements inside each unit represent cutout in floor to allow for drain/overflow.
4. All measurements are in inches. To convert to millimeters, multiply inches by 25.4.
5. Not all export units come with pre-installed Pump/Motor.
35"
44"
60"
60"
46"
27-1/4"
35"
14" x 4"*
27-1/4"
Ref.
61-5/8"
- 2" x 4" Stud
TARA ™ PLUS, Right Hand
Heater Motor
Service
Access
Opt. Service Access
25-1/2"
(648 mm)
58"
(1473 mm)
45-9/16"
(1157 mm)
58"
(1473 mm)
25-1/2"
(648 mm)
Ref.
59"
TARA PLUS RH CUTOUT
Drain Cutout
Motor
Heater
- 2" x 4" Stud
14" x 4"*
Heater (S)
Motor
12" H x 24" L
Service Access
Opt. Service
Access
TARA™ PLUS Left-hand BACK MOTOR
46"
35"
35"
27-1/4"
27-1/4"
44"
60"
60"
Ref.
61-5/8"
25-1/2"
(648 mm)
58"
(1473 mm)
45-9/16"
(1157 mm)
TARA ™ PLUS Left-Hand BACK MOTOR
58"
(1473 mm)
25-1/2"
(648 mm)
Ref.
59"
CUTOUT
Motor
Drain Cutout
Heater
- 2" x 4" Stud
35"
44"
60"
60"
46"
27-1/4"
35"
14" x 4"*
27-1/4"
Ref.
61-5/8"
Heater (S)
Motor
12" H x 24" L
Service Access
Opt. Service
Access
TARA™ PLUS Right-hand BACK MOTOR
25-1/2"
(648 mm)
58"
(1473 mm)
45-9/16"
(1157 mm)
58"
(1473 mm)
25-1/2"
(648 mm)
Ref.
59"
CUTOUT
Motor
TARA ™ PLUS Right-Hand BACK MOTOR
Drain Cutout
Heater