JVC MP-XV841US - Manual (Page 65)

EN
65
Using an External Monitor
To attach an external monitor to your PC, use the external display cable.
Connecting an external monitor
When you connect an external monitor to your PC, it looks like an ordinary desktop PC. You
can use the monitor by just connecting it with the external display cable. You can display
images on the external monitor for other people and you can watch them on the LCD panel of
your PC.
For switching the display between the external
monitor (CRT) and LCD panel of your PC, press
the Fn + F10 keys, and the mode will be switched
in the following sequence:
LCD (LCD panel of PC) ¥
CRT (external monitor) ¥ LCD + CRT
Notes
• When disconnecting the external display cable,
be absolutely sure to pull it straight out while
pressing the push areas at the two
ends.
• No switching results when the
Fn + F10 keys are pressed if the CRT
(external monitor) is not connected.
• Do not disconnect the VGA cable
during operation in the CRT (external
monitor) mode. The mode will not be switched by operating the Fn + F10 keys while this
cable is disconnected. To enable the operation of these keys in this state, the VGA cable
must be re-connected. It is a good idea to switch to the LCD + CRT mode first before
disconnecting the VGA cable.
Changing the external display's resolution
1 Switch over to the external display, right-click anywhere on
the screen, and click [Properties].
2 When the “Display Properties” screen has appeared, click the
[Settings] tab.
3 Move the [Screen resolution] bar to change the resolution.
4 Click [OK] to enter the new resolution setting.
Insert in accordance with the direction of the
terminal on your PC.
Screen resolution bar
04.5.10, 7:18 PM 65