JVC CA-UXL36V - Manual (Page 14)

– 11 –
English
Reinforcing the Surround Effect
(ONLY FOR UX-L46V)
You can reinforce the surround effect.
• This function does not affect
—your recording.
—playback sound of the monaural sources.
To get the effect, press SURROUND so that the
SURROUND indicator lights up on the display.
To cancel the effect, press SURROUND again so
that the SURROUND indicator goes off.
Selecting the Illumination Brightness
You can change the illumination brightness only while the
unit is turned on.
On the remote control ONLY:
To change the brightness, press DIMMER.
• Each time you press the button, the illumination
dims and brightens alternately.
BASS
AHB OFF
(Canceled)
AHB 1 AHB 2
SURROUND
SURROUND
DIMMER
SURROUND
AHB PRO
AHB PRO
BASS TREBLE
UP DOWN
PREV NEXT UP
DOWN
Adjusting the Tone (Bass/Treble)
You can adjust the bass level (low frequency range) and the
treble level (high frequency range) within the range of –5 to
+5. Normally set these to 2 (initial setting at factory).
• This function only affects the playback sound, but does not
affect your recording.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
1
Press BASS to adjust the bass level or press
TREBLE to adjust the treble level.
2
Press UP to increase the level or press DOWN
to decrease it.
Reinforcing the Bass Sound
You can reinforce the bass sound to maintain rich, full bass at
low volume.
• This function only affects the playback sound, but does not
affect your recording.
To get the effect, press AHB (Active Hyper Bass)
PRO until “AHB 1” or “AHB 2” appears on the
display. The BASS indicator also lights up on the
display.
• Each time you press the button, the bass sound
change as follows:
“AHB 2” has much more bass reinforcement effect than
“AHB 1.”
To cancel the effect, press AHB PRO until “AHB OFF”
appears on the display and the BASS indicator goes off.
EN01-14_UX-L46&36[US&UJ]f 28/5/2002, 3:58 PM 11