Jameco Electronics Superpro Series - Manual (Page 11)

Figure 8 Data type
2.1.2 Save
This selection will save the current data in the buffer to disk.
For E(E)PROM, BPROM or MCU device types, Save File window will pop up. Select
the folder and filename to be saved under. Next, File Type dialog box will pop up for
selecting file type to be saved under.
For PLD devices, the Save JED File dialogue box will pop-up to enter the file name.
2.1.3 Exit
This command closes the programmer software and returns you to the control of the
operating system.
2.2 Buffer: <Alt-B>
The menu manages data in the buffer.
2.2.1 Edit
The selection brings up Fuse Buffer Edit window if the device type is a PLD, or Data
Buffer Edit window for memory/MCU devices. The HEX/ASCII data buffer is 8 bit
wide. Tab key may be used to switch between HEX and ASCII data for edit. You may
edit the buffer data on the screen with the following keys:
<PageUp> :Page
up
<PageDown> :Page down
<Ctrl-PageUp>
:Move cursor to the beginning of the buffer
<Ctrl-PageDown> :Move cursor to the end of the buffer
<Home> :Move cursor to the beginning of the line
<End> :Move cursor to the end of the line