Jameco Electronics Superpro Series - Manual (Page 17)

Chip End
Input an address for the chip where you would like a selected function of downloading or
uploading to end. This is normally set to the end address of the chip.
Buff Start
This sets the address in the buffer where file loading begins. By changing the address, a
file can be loaded at any desired location.
Buff End
This sets address in the buffer where file loading ends. By changing the address, a file
can end loading at any desired location.
Note: Chip Start, Chip End, Buff Start, and Buff End, are used in multiple file
loading and offset programming. Multiple loading allows the buffer to be filled with
different files at different location. Offset programming allow the chip start address toi
be other than at zero.
2.3.2 EditAuto
Functions included in the Auto menu may be edited using the EditAuto menu. In the
Edit-Auto dialog box double click on the functions listed in the left column to be
included in the Auto sequence. New Auto sequence is created and saved as a file.
Figure 16. Edit Auto
2.3.3 Select( Device)
This selection brings up the Select Device dialogue box, which includes Manufacturer
List viewer, Device List viewer, Type radio button, OK and Cancel buttons and Search