Jameco Electronics Superpro Series - Manual (Page 8)

switch and observe the power LED coming on bright. Please be sure not to insert any chip
onto the programmer socket at this time.
1.2.3
Running the Program
Please run the main program for the programmer. If everything is set up correctly, then
the main screen should come up without any error message. At this point, you may select
a device and proceed with programming operation.
Figure1. Main Screen
1.2.4
Communication Error Message
Communication error may occur if the PC failed to communicate with the programmer.
Please check the setup again and see to it that there is no device inserted in the
programmer socket.
Sometimes, the error message occurs when the programmer hardware is defective. If the
problem persists please contact factory for support.