JVC TK-C926EG - Manual (Page 3)

3
16.
a. When the power cord or plug is damaged or frayed.
b. If liquid has been spilled into the appliance.
c. If the appliance has been exposed to rain or water.
d.
e. If the appliance has been dropped or the cabinet has been damaged.
f.
17.
18.
If the appliance does not operate normally by following the
operating instructions. Adjust only those controls that are covered
by the operating instructions as improper adjustment of other
controls may result in damage and will often require extensive work
by a qualified technician to restore the appliance to normal
operation.
13.
14.
15.
Never push objects of any kind into this appliance through cabinet slots
as they may touch dangerous voltage points or short out parts that
could result in a fire or electric shock. Never spill liquid of any kind on
the appliance.
Do not attempt to service this appliance yourself as opening or
removing covers may expose you to dangerous voltage or other
hazards. Refer all servicing to qualified service personnel.
Unplug this appliance from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
When the appliance exhibits a distinct change in performance - this
indicates a need for service.
When replacement parts are required, be sure the service technician
has used replacement parts specified by the manufacturer that have
the same characteristics as the original part. Unauthorized
substitutions may result in fire, electric shock, or other hazards.
Upon completion of any service or repairs to this appliance, ask the
service technician to perform routine safety checks to determine that
the appliance is in safe operating condition.
Do not overload wall outlets and extension cords as this can result in
fire or electric shock.
11.
12.
Follow all warnings and instructions marked on the appliance.
Do not allow anything to rest on the power cord. Do not locate this
appliance where the cord will be abused by persons walking on it.
TK-C925_EN.book Page 3 Thursday, November 23, 2006 4:33 PM